Have you been apprehensive about pricking your fingers to know your glucose level? Fear no more as American scientists have recently developed the model of a portable glucose monitor.
According to a News18 report, this device is "the first of its kind" that uses sweat on the skin, rather than needles.
In the study, Laser-induced graphene non-enzymatic glucose sensors for on-body measurements, published in the journal Biosensors and Bioelectronics, a team of researchers from Pennsylvania State University initially developed a device with laser-induced graphene or LIG, a material comprising layers of carbon and thickness of an atom in various types.
While the said LIG seemed to be an ideal setting for the monitoring or detecting device, the report specified that it was "not at all sensitive to glucose."
ALSO READ: Thermoelectric Materials Made Using Novel Synthesis Strategy
People apprehensive about pricking their fingers to monitor their glucose level will fear no more as American scientists have recently developed the model of a portable glucose monitor.
Nickel for Strong Sensitivity to Glucose
Addressing the flaw, the team then opted for nickel due to its strong sensitivity to glucose and combined it with gold to lessen the possible risk of an allergic reaction.
While the glucose concentration in sweat is roughly 100 times lower than the concentration in blood, this new device of the team is sensitive enough to measure glucose accurately in the seat and have the concentration reflected in the blood.
A New in 24 reports said that according to Huanyu "Larry Cheng," a Penn State Department of Engineering and Mechanical Sciences professor, the sensitivity of the nickel-gold alloy enabled the team to rule out enzymes, which are frequently used to measure glucose in more invasive, not to mention commercially available devices.
Nevertheless, non-enzymatic sensors necessitate an alkaline solution, which can impair the skin, and in general, limits the device's portability.
Microfluidic Chamber Attached to the LIG
To control the possible damage, the researchers attached a microfluidic chamber to the LIG allow, which is linked to a collection inlet that enables sweat to pass through the solution minus enabling it to touch the skin.
The basic solution is interacting with the glucose molecules to generate a compound that is reacting with the allow.
Such a reaction is activating an electrical signal that indicates the concentration of glucose in sweat, explained Cheng.
Conducting a proof-of-concept test, the study authors used an adhesive that's safe to use in skin, to attach to the wearable device, specifically worn over the arm of a person, one hour and three hours following a meal.
A Decline in Glucose Concentration
Before every measurement beat, the subject was tasked to perform a brief training session, just adequate to generate sweat.
After a few minutes of collecting the seat, the researchers discovered that the detected concentration of glucose dropped from the initial measurement to the succeeding one.
Essentially, glucose readings from the device were validated by measurements made using a glucose meter that's commercially available.
Commenting on the invention, Cheng said they want to work with doctors, as well as other healthcare providers to find out how their technology can be applied for the patient's daily monitoring.
He added this glucose sensor serves as an ultimate example to show that the detection of biomarkers in sweat can be enhanced at very low concentrations, a similar report from the Mental Daily site said.
Related information about non-invasive glucose monitoring devices is shown on TechCrunch's YouTube video below:
RELATED ARTICLE: Graphene-based supercapacitor has the potential to power wearable electronics
Check out more news and information on Medicine & Health and Tech & Innovation in Science Times.